How to use

Before you start, first clean the lashes :

Make sure your natural lashes are clean and free of oils and makeup.

1. Apply the bond

Apply the bond under your own lashes. Do this at the base of your lashes over the entire width so that all extensions have sufficient support.

2. Apply the lashes

Carefully take one lash at a time from the packaging with the tweezer. Place the lashes one by one next to each other under your own lashes on the applied bond. Start from the outside in. Press all lashes with the tweezer to adhere the lashes well.

We recommend using 4-5 lashes per eye depending on your eye width.

We recommend not getting your lashes wet for the first 12 hours to give the lashes and bond time to bond properly. This will ensure your lashes stay waterproof for the next 5-7 days.

3. Apply the seal

Then, if desired, you can apply the seal to make the lashes stay in place even longer. You do this by applying the seal under your lashes over the entire width of the lashes. This will make the lashes waterproof and stay in place for the next 10-12 days.

4. Remove

You can remove the lashes by applying our lash remover to all applied lashes. Then let it sit for 3/5 minutes. Then you can carefully pull the lashes off your lashes 1 by 1 with the tweezer .

You can clean your own lashes by wiping them with a cotton pad soaked in make-up remover.

5. Cleaning

You can clean the lashes so that you can reuse them 3-4 times. Put the lashes in Denatured alcohol 70% for 2-3 sec. Then you can easily remove the glue residue.